I'm assuming the standard ones are similar. There's quite a bit of cabling on the LED inicators. The second issue is fitting the cabling in. my suggestion is to firmly finger tighten and then use superglue. I was just using some needle nosed pliers to tighten the very small nuts but still overbaked it. When tightening the nuts that hold on the numberplate light in place, with very little effort I managed to over tighten them, meaning one sheared and one pulled straight out of the light unit. Once the old holder was removed, installing the R&G tidy was relatively straight forward, except for two issues.

That was a good two hours wasted getting them out. Despite my best efforts, I managed to strip two of them - they were bolted in mega tight. Whoever put the four main allen bolts in wasn't planning on them coming out again. To be fair, the majority of my problems were not related to the R&G kit, it was more to do with the removal of the existing licence plate holder. Looking at the instructions it seemed a pretty straightforward job, probably not much more than an hour.

I finally got around to ordering the R&G tail tidy and installed it today.

Tail tidy for ducati supersport